Dry coke quenching study

  • 25 Pages
  • 1.77 MB
  • 4322 Downloads
  • English
by
Dept. of Energy, for sale by the National Technical Information Service] , [Washington], [Springfield, Va
Coke -- Quen
StatementNational Steel Corporation, Engineering Dept
SeriesCOO ; 4553-1
ContributionsUnited States. Dept. of Energy
The Physical Object
Pagination25 p. ;
ID Numbers
Open LibraryOL14877823M

Get this from a library. Dry coke quenching study. [National Steel Corporation. Engineering Department.; United States. Department of Energy.]. Abstract Compared with wet quenching, coke dry quenching technology can increase the M40 and M10 of coke by % and % respectively, and decrease release of the pollutants, such as ammonia, phenol, cyanide and so on.

The coke is taken to the quench tower, where it is cooled with a water spray or by circulating an inert gas (nitrogen), a process known as dry quenching. The coke is screened and sent to a Dry coke quenching study book furnace or to storage. Coke oven gas is cooled, and by-products are recovered.

The purpose of coke quenching is to quench the incandescent coke in the hot car using intense water sprays covering entire cross-section of the red hot coke bed and preventing it from burning, at the same time to obtain coke of uniform and minimum deviations in coke moisture.

This case study presents a simple approach of developing a Standard. In order to improve the quality of coke, the technology of dry quenching was widely used in recent years. Compared with wet quenching, the dry quenching technology can increase the M40 and M10 of coke by % and % respectively.

This is advantageous to reduce ironmaking costs and improve pig iron outputs. The cold inert gas was. Wet quenching Dry quenching 15 15 CO2 CO H2 N2 Sample CDQ operating data˜ ˜ CDQ plants Comparison of CDQ coke quality Outline of technology Red-hot coke Processing capacity: t/hr Temperature: Approx.

1,oC Boiler inlet gas temperature: Approx. oC Energy recovery balance CDQ chambers Temperature of discharged coke: Approx. oCFile Size: 69KB. Owing to its merits in energy savings, environmental protection and coke quality improvement, the Coke Dry Quenching (CDQ) technology is favorite in coke making industry today.

In order to validate the mathematical model developed for the cooling. Key Words: Coke Oven, CDQ, based on the nonBFG Injection, Steam Generation model for the cooling process of the CDQ experimental.

INTRODUCTION. CDQ Plant recovers the coke oven sensible heat of hot coke by use of circulating gas, feed the recovered heat to. Types of Heat Treatment. Quenching Media. To hear audio, click on the box.

Overview. Welding, cutting, or even grinding on metal produces heat, which it turn has an effect on the structure of the metal. As a Steelworker, you need to understand the effect that heat.

3.) Put coke into preheated oven for 15 minutes, then turn OFF the heat, but do not remove the coke. Do not open the oven door to peek in.

Download Dry coke quenching study PDF

Let the dry air in the oven do it's work. 4.) Let your coke sit in the oven at least 30 minutes after you turned it off. 5.) Remove your dry coke, chop it up, and store it in an airtight container with a.

The coke dry quenching (CDQ) system To quench Dry coke quenching study book in the steel making industry means to cool it from approximately to °C in order to inhibit its combustion and gasification. The CDQ technique was introduced in Switzerland by the Sulzer brothers in the by: coke is cooled gradually in chamber by the use of cooling a result, the coke is free from surface pore due to aquatic gasification reaction and internal crack that occur in wet quenching.

In addition, brittle portions of coke are removed when it drops in the chamber. *1 Drum Index *2 Coke strength after-CO2 Reaction Size: KB. In this study, a project of coke dry quenching (CDQ) and utilization of its waste heat for electricity is used as a case to reveal the improved efficiency of energy and CO 2 emission reductions.

The analyses are conducted based on using the ACM methodology of clean development mechanism(CDM).It is found that the expected annual power. Coke Dry Quenching Technology: Review and Case Study of First CDQ Project in Iran Abstract: The purpose of this article is to review the best technologies used in the hot coke quenching process while focusing on Coke Dry Quenching (CDQ) technology which uses inert gas instead of water (thus the term “dry”) to cool down the hot coke.

In a self-designed experimental apparatus, coke oven gas, H2, CO, CH4, CO2 and N2 as coke dry quenching medium, coke as the filler of bed, the influences of particle shape, particle size, the gas. CDQ (Coke Dry Quenching) is a gradual coke quenching system, and improves coke strength and coke size distribution.

Consequently, while the blending ratio of inexpensive non- or slightly-caking coal for coke oven material is only approx. 15% in case of CWQ (Coke Wet Quenching) system, it can be increased up to approx. Title: Computational and experimental study of cooling process in Coke Dry Quenching experimental shaft: Authors: Liu, Huafei; Zhang, Xinxin; Wu, Maolin; Feng, Yanhui; Wang, Yingbo; Wang, Dinan; Xu, Lie; Zheng, Wenghua: Affiliation: AA(School of Mechanical Engineering, University of Science & Technology Beijing), AB(School of Mechanical Engineering, University of Science & Technology.

In the present research work, adding a certain amount of coke dry quenching(CDQ) dust to pulverized coal used in blast furnace is proposed for efficient utilization of resources and reducing smelting cost.

The properties of coal blends and coal/dust blends were investigated by using long tube tester and the device of thermogravimetry (TG).Cited by: 1. Coke Dry Quenching Traditionally dry quenching process is being adopted for the cooling of Coke produced from the Coke Oven Battery in Steel Plants.

Water is used as cooling media to cool the hot coke which not only consumes large volume of water but also releases harmful pollutants which is also not permitted buy the government latest regulations. Coke Dry Quenching. Traditionally dry quenching process is being adopted for the cooling of Coke produced from the Coke Oven Battery in Steel Plants.

Water is used as cooling media to cool the hot coke which not only consumes large volume of water but also releases harmful pollutants which is also not permitted buy the government latest regulations.

- Coal Carbonization and Coke Oven Plant Chemical Engineering Notes | EduRev is made by best teachers of Chemical Engineering.

This document is highly rated by Chemical Engineering students and has been viewed times/5(4). Subsequently to a 15 to 25 hours coking time the doors are opened and the built coke is pushed by the coke pusher machine out of the oven into a coke quench the coke is quenched in a dry or wet quenching facility.

The oven chamber is sealedagain, initiating a new carbonization by: 2. In this paper, a new coke dry quenching (n-CDQ) technology is proposed. The advantages of this technology are energy conservation, pollution reduction, coke quality improvement and the full use of resources.

Based on the idea of the n-CDQ technology, process modeling is conducted using the process simulator of Aspen Plus. The impacts of the flow of the coke-cooling coke oven gas Author: Lan Yi Sun, Jun Ting Wu, Jin Chuan Xu, Qing Song Li.

Abstract. Analysis of the construction and operation of coke quenching chambers facilitates the identification of their deficiencies. The elimination of these deficiencies permits increase in operational efficiency of existing dry-quenching systems and the development of new high-performance by: 2.

Effects of different methods of quenching on metallurgical coke properties in laboratory and coke plant conditions were studied. The various technological measures, like, coal blend preparation, carbonization, etc. are not enough for upgrading the coke quality.

Therefore, quenching of coke is an important area for improving the coke by: 1. Steel Manufacturing Process: Coal & Coke - Duration: AIST Association for Iron & Steel Technol views. Conventional wet quenching is estimated to produce 36 Kg of coke breeze per Mg of coke produced. This added to the Kg/Mg from the gas cleaning car yields Kg/Mg coke ( Ibs/ton) of particulate in the clarifier sludge ( Kg/Mg at Mg/hr coke rate).

Description Dry coke quenching study EPUB

• CDQ (Coke Dry Quenching) is a gradual coke quenching system, and improves coke strength and coke size distribution. Consequently, while the blending ratio of inexpensive non- or slightly-caking coal for coke oven material is only approx.

15% in case of CWQ (Coke Wet Quenching) system, it can be increased up to approx. 30% by CDQ. processing is coke quenching done in wet or dry way. It was found out that stamp blends coke which was dry quenched in dry quenching chambers of coke plant with other equal conditions (charge content, preparation and coking technological regime) is characterized by lower rate of CRI and higher rate of CSR than wet quenched coke [4].

In that way, dust contents of less than 10g/ton of coke and coke water contents of less than 3% are reached.

Details Dry coke quenching study EPUB

Dry quenching system Through the strategic alliance with IHI Corporation within the joint venture Paul Wurth IHI, the Group offers coke dry quenching (CDQ) technology, relying on a proven track record of CDQ plants.

METHODOLOGY FOR COKEMAKING TECHNOLOGY SELECTION FOR OPERATING CONDITIONS AND EXPANSION OF IRON AND STEEL WORKS and Coke Dry Quenching (CDQ) which produce higher quality coke then Wet Quenching (WQ), as well as power from CDQ are assessed.

Air and The main goal of the study was to develop a technology strategy to meet the future coke re.Wet quenching of coke in the packed towers with cellular packing is not my idea. The water content in coke is in the range of %.

I will try to find English version of the text about this issue.Dry coke quenching study. Final report, September Technical Report.

The financial evaluation of capital and operating cost estimates for a dry coke quenching facility installation indicates a marginal return on investment if the evaluation is based exclusively on steam credits. However, the potential improvements in environmental.